Note: There are two situations for the installation of T8LED tubes. When installing,T8 tube light remove the original fluorescent lamp and replace it with an LED fluorescent lamp, and remove the ballast and starter,T8 tube light so that 220V AC mains power is directly added to the two ends of the LED fluorescent lamp. can. (Common in domestic and EU) When installing,T8 tube light remove the original fluorescent lamp and replace it with an LED fluorescent lamp, and remove the ballast and starter,T8 tube light so that the 220V AC mains power is directly added to the same end of the LED fluorescent lamp. (American Standard)
Installation: T8LED tube comes with a constant current source,T8 tube light no ballast or starter is needed. Generally,T8 tube light for lamps above T8, because the lamp space is large enough, the constant current source can be installed in the lamp. Therefore,T8 tube light during installation, the ballast and starter in the original bracket can be removed without use,T8 tube light and the lamp tube can be installed directly.
Voltage: Although the fluorescent lamp produced has a wide voltage adaptability,T8 tube light it can work normally if it is AC 85V-AC 245V. But the long-term voltage is too high or too low, it will affect the power factor of the constant current source,T8 tube light that is to say, it will have a slight impact on the energy-saving effect. At the same time,T8 tube light it will also affect the life of the constant current source. Therefore,T8 tube light it is generally necessary to choose a fluorescent tube with a suitable voltage. For example,T8 tube light where the mains power is 110V, we should use our specially designed 110 mains fluorescent tubes.
Heat dissipation: The fluorescent lamp produced is equipped with a heat dissipation shell made of aluminum. Under normal circumstances,T8 tube light there is no problem with heat dissipation. However,T8 tube light if it is used in a place with heavy dust,T8 tube light it should be cleaned regularly to prevent dust from covering the radiator and affecting heat dissipation. Waterproof: LED fluorescent tube is composed of upper and lower parts: the upper part is an aluminum radiator,T8 tube light and the lower part is a diffuser. There are gaps in the connection. Therefore,T8 tube light it is necessary to prevent oil smoke and water vapor from entering. If it is used in a place with heavy smoke and water vapor,T8 tube light it is recommended to add a protective cover. A general protective cover will do.
Vibration: LED fluorescent lamp has strong anti-vibration ability. As long as it is not a violent impact,T8 tube light it will generally not cause damage. However,T8 tube light it may have a certain impact on the diffuser. The traditional fluorescent lamp is made of glass,T8 tube light and the inside is close to a vacuum. Vibration may cause an explosion. Pay special attention to the vibration.
